Ways to connect O-ring Chains Remarks to connect standard O-ring Chains

1.A connecting hyperlink of an O-ring Chain for general application is pre-coated with grease with the pins. In advance of connection, confirm the grease around the surfaces of pins, and should the volume of grease is modest, apply grease with bare hands. (If gloves are made use of, the grease will be absorbed by the gloves.)
Illustration: Once the connecting website link (I) of an O-ring chain for standard application is
shipped, O-rings are fitted with the roots of your pins. When the O-rings come loose as a result of vibration for the duration of transport, refit the O-rings in to the roots in the pins.
In this case, you’ll want to return the grease collected with the roots with the pins on the central surfaces of the pins, a lot more at portion A than at portions B shown during the over illustration. (Portions A is worn on account of sliding with the bushings.)
two.The chain is often most conveniently linked about the teeth of the sprocket. Engage the hyperlinks at both ends of your chain with the sprocket teeth and fit connecting pins. If your sprocket may be moved, the chain may also be connected about the loosened side.
3. Connecting process
one.Verify that O-rings are attached on the roots of the pins.
two.If the amount of grease applied around the connecting pins is modest, coat the pins with grease with the central portions.
3.Insert the connecting pins into the bushings from the inner backlinks at each ends.
4.Confirm the grease is utilized towards the complete face of your O-ring, and match the O-ring onto the connecting pins.
five.Insert the connecting pins to the connecting plate and though pressing the connecting plate, set up the spring clip. Verify irrespective of whether the head (the end with no split) with the spring clip is turned in the feeding course of your chain. (See the next illustration.)
6.You’ll want to confirm that the spring clip is securely fitted during the clip grooves with the connecting pins.
This completes jointing of the connecting website link. Note that grease to the surfaces of connecting pins and O-rings can be removed all through set up operate. In this instance, re-grease utilizing the grease within the surface on the base chain or the grease inside the polyethylene bag in which the connecting hyperlink was contained.